Winbook LM Installationshandbuch

PCMCIAPortable HARD DISKInstallation ManualHD Traveler

INSTALL THE WINDOWS NT 4.0 DEVICE DRIVERCurrently there is no Plug and Play support for the Windows NT 4.0, Userneed to insert the HD PC Card while th

PCMCIA SOFTWARE (DOS/WINDOWS3.X) INFORMATIONIf you have installed the PCMCIA software, such as SystemSoft’s CardSoftor Databook’s Cardtalk, then EXPHD

SYSTEMSOFT PCMCIA SOFTWARE SAMPLE CONFIG.SYS FILELASTDRIVE=ZDEVICE=C:\DOS\HIMEM.SYSDEVICE=C:\DOS\EMM386.EXE NOEMS X=D000-D3FFFILES=40BUFFERS=20STACKS=

POWER SAVINGThe HD TRAVELER drive will automatically enter the sleep mode (spindleoff) when it has not been accessed for about 4 minutes.The “Hot inse

APPENDIX BWINDOWS 95’s MS-DOS Mode for the HD TravelerThis procedure will allow you to use the HD Traveler in a pure MS-DOSenvironment for those appli

Click on the “Advanced”• Click the “MS-DOS mode” Click on “Specify a new MS-DOSconfiguration”• Click on “OK”. Thenclick on “OK”. This isthe end of th

EXP COMPUTER, INC. EXP MEMORY PRODUCTS.NON-TRANSFERABLE LIMITED WARRANTYEXP COMPUTER INC., AND EXP MEMORY PRODUCTS("EXP") warrants that the

Table of ContentINTRODUCTION 1SYSTEM REQUIREMENTSFEATURESPART NAME AND FUNCTIONSHARDWARE INSTALLATION 3SOFTWARE INSTALLATION FOR DOS/WINDOWS 3.1 4AUTO

PART NAMES AND FUNCTIONS1. Game Port15-pin game port connector for joystick or game-pad2. Hard Diskhard disk with the power indicator and the 5V DC in

SOFTWARE INSTALLATION FOR DOS/WINDOWS 3.1AUTOMATIC INSTALLATIONThe device driver installation programs provide a simple INSTALL programto help you to

MANUAL INSTALLATIONYou may manually install the HD TRAVELER device driver if the defaultsetting conflicts with your system. Try the following procedur

SOFTWARE INSTALLATION FOR WINDOWS 95USING THE HD TRAVELER UNDER WINDOWS 95The following dialog box will appear when you use the HD TRAVELER underWindo

REMOVING OR RE-INSTALLING THE DRIVERYou can always change the configuration by removing the driver andreinstalling again. To remove the driver -A.) If

In this case, double click the PCMCIA Controller and a dialog box will bedisplayed as below. Please place a check mark next to the currentconfiguratio